elwoodblues1969
Kara-Moon Master
Posts: 4478
Studiophile,Audiophile & Synthophile.
|
|
« on: January 15, 2010, 05:17:24 AM » |
|
Moon,
At this point in time-I feel like a bleeding imbecile,because time & time again,I am running into brick walls with my M3,despite the fact that I am a seasoned Korg user. I may seem lazy by now...as if I just want to be spoon-fed,but actually,I have been all over the internet..frantically trying to obtain information on what should be a very simple procedure,which is that I merely wish to remove my M3 module,so that I can install the EXB256 board. I've looked through the manual,the supplementary guide,the Karma-Lab site,the Korg main website and YouTube,but I still have yet to figure out how to remove the module.
The manual shows how to install the card itself,but fails to mention that you NEED to remove the module first and needless to say,does not tell you HOW to remove the module. In all my searching-the only progress I made,was that I found a video on YouTube on how to install the card,but this guy states one does not need to remove the module to install the chip & this guy claims he installed it without removing the module. This guy really pissed me off to no end,because it's inconceivable to me how he did it,because the space is much too tight & restrictive,to get a screwdriver in there.The most frustrating part of all this,is that on my Triton Extreme,all I had to do was simply remove the panel on TOP of the keyboard and I was easily able to install a memory chip without any instruction whatsoever. At this particular juncture,I am really dreading the thought of having to go through this again,once I buy the Radias board.Please tell me how you installed this board,as I would really appreciate it!Thanks,
-Thom
|